Contour measurement: Please scan
The principle of contour measurement
In the field of contour measurement, an important aspect of quality control, different probe needles slide over the component in one direction. These special measuring instruments are used to capture and analyze the surface profile of a component.
During contour measurement, the appropriate probe needle for the testing task is guided over the component. During this process, the measuring arm records all deflections that occur through the interaction of the probe needle with the surface of the component.
These recorded deflections are then converted into a two-dimensional curve. From this 2D curve, the desired dimensions can finally be determined. These dimensions can be visualized and used for further analysis and quality assurance.
Before testing, it is essential to clean the components. Contaminants such as oil can influence the measurement and falsify the results. Therefore, only clean samples are measured on the device. The coefficient of thermal expansion also plays a crucial role in the conformity of the components. For this reason, the dimensional tests take place in a climate-controlled measuring room.
Your benefits
- Precise determination of the component profile, even in accessible cavities
- Various probes enable a wide range of testing tasks
- Software-supported zenith search on round components for precise measuring position
Contact
We are here for you!
Please contact us at +49 7931 91-1595 or send an e-mail to lab_request@wuerth-industry.com.
The Würth Industrie Service GmbH & Co. KG collects and processes the personal data provided in the form in order to process the requested request for you. Please note the mandatory fields in the forms. The legal basis for this processing, the absolutely necessary data, is Art. 6 para. 1 lit. b DSGVO, implementation of a pre-contractual measure. The processing of data voluntarily provided by you is carried out on the basis of Art. 6 para. 1 lit. f DSGVO. Thereafter, processing is permissible which is necessary to safeguard our legitimate interests. Our legitimate interest is to have contact with you, our customers, to improve our consulting quality and to be able to contact you more easily in case of possible queries. The data collected will only be stored by us for as long as is necessary to process your enquiry and to contact you. They are then deleted.
Supplementary data protection information, in particular regarding your rights to information, correction, deletion, restriction of processing, objection and complaint, can be found in our data protection declaration.